IBDozing Discussion Groups: HD6 Transmission jumps out of gear

HD6 Transmission jumps out of gear

IBDozing Discussion Groups: Allis Chalmers (Monarch, Allis Chalmers and Fiat Allis): HD6 Transmission jumps out of gear

HD6E Crawer Dozer Tracks October 16 - 10:14 am
HD6G Clutch locking ajustment pin broke May 08 - 11:48 am
HD6 Transmission jups out of gear March 19 - 11:08 am

By Nelson Hicks on Tuesday, March 18, 2008 - 12:11 pm:

I have a HD6-E dozer that the transmission jumps out of gear when it starts to push. Has anyone had this problem.Help
e-mail dhicks31@hotmail.com

By hector gemme on Tuesday, March 18, 2008 - 4:13 pm:

You need to adjusted the rod locking plunger

By Nelson Hicks on Wednesday, March 19, 2008 - 11:11 am:

Thanks for the info, Is this part of the hand clutch adjustment or just the plunger only. When I purchase the dozer this was part of the problems it had. The plunger boots has been replaced due to bad oil leak

By hector gemme on Wednesday, March 19, 2008 - 2:49 pm:

The rod adjustement is on right side and he is connect to the cluch shaft to the housing shift lever and you adjusted near the boot joint.
gemdozer@hotmail.com

			This is a public posting area. Enter your username and password if you have an account. Otherwise, enter your full name as your username and leave the password blank. Your e-mail address is optional.
Username:
Password:
E-mail:

Add a Message